#ZEBRA SCANNER ENTER AFTER SCAN UPDATE#
#ZEBRA SCANNER ENTER AFTER SCAN PC#

#ZEBRA SCANNER ENTER AFTER SCAN PC#

If you are unable to scan any of the barcodes above try printing the LI4278 Quick Start Guide.Ĭradle has no light but temporarily presents a light when the PC is rebooted If you can't scan large cartons or case barcodes please scan this barcode to activate. In the example below, we have added the Carriage Return (Enter Key), which means the product will automatically be added to the sell screen. In this example, the Carriage Return (Enter Key) has not been configured, resulting in the barcode remaining in the search bar instead of adding the product to the sales screen.Įxample 2: Carriage Return (Enter Key) Configured Example 1: Carriage Return (Enter Key) Not Configured If you scan a barcode and it remains in the Shopfront search bar without being added to the sale, simply scan the barcodes provided above to rectify the issue. To add an Enter key after scanned data, please scan all three bar codes in numerical order.

#ZEBRA SCANNER ENTER AFTER SCAN UPDATE#

Update the scanner's firmware by downloading the 123 Scan UtilityĪdd a Carriage Return (Enter Key): (Carriage Return/Line Feed).Scan the Set Factory Defaults barcode (below) followed by the Add an Enter Key barcodes in sequence.You will need a Philips head screwdriver to disconnect the battery. Disconnect the battery from the bottom of the barcode scanner temporarily and then plug it back in.After the LI4278 resets release the trigger and remove it from the cradle.While resetting the scanner should emit power-up beeps.A red led light should start blinking on the LI4278 signalling that it started re-initialising/resetting.

Pull and hold the LI4278 trigger for approximately 20-30 seconds.Disconnect the cradle cable from the PC end and plug it into a different USB port.The cable has an end like a telephone cable with a plastic clip. Disconnect the cable at the bottom of the cradle.Note Between each step please try scanning a product barcode to see if the issue has been resolved. The steps below regard the models LS4278 or LI4278. If the scanner beeps 3 times after an unsuccessful scan then please complete the steps below to troubleshoot your device. If the scanner loses power after scanning a barcode and is more than two years old then the battery may need replacing which we can supply. If your wireless barcode scanner is not scanning properly it might be due to a low battery or it might require troubleshooting.

Zebra scanner enter after scan